Parts needed
Tools needed
- 15 mm Crescent Wrench
- 5 mm Hex Key
Step 1: Remove both pedals using 15 mm crescent wrench.
Step 2: Remove both wheels. For wheels with nuts, use 15 mm crescent wrench.
Step 3: Insert dropout protectors into front and rear dropouts.
Step 4: Open Physis Handlepost lever. Remove Top Cap and loosen Top Cap Bolt.
Step 5: Loosen both Steerer Clamp Bolts using 5 mm Hex Key.
Step 6: Detach Physis Handlepost from frame.
Step 7: Put Top Cap, then Top Cap Bolt back onto steering tube and tighten.
Step 8: If bike has rack or front fender, remove them. Remove seat post. Lay out all parts on floor.
Step 9: Fold frame and put handlepost and handlebar socks over handlepost and handlebar.
Step 10: Place AirPorter Slim on floor, open cover, and lay buckles on outside.
Step 11: Place QR skewers into designated slots.
Step 12: Place frame on top of padding with front frame half underneath rear frame half. Lay handlebar assembly on upper section of Airporter Slim. Rotate crank as shown below.
Step 13: Place pedals in pedal bag. Then place as shown below.
Step 14: Place padding on seatpost. Then place as shown below.
Step 15: If bike has front fender, place it inside as shown below.
Step 16: If bike has rear rack, place it inside as shown below.
Step 17: Place handlebar assembly onto frame.
Step 18: Fold padding over.
Step 19: Place Rear Wheel on padding with cassette facing padding.
Step 20: Place Front Wheel on padding partially overlapping Rear Wheel.
Step 21: Fold padding over wheels.
Step 22: Clasp buckles shut and cinch tightly.
Step 23: Align top and bottom halves of Airporter Slim.
Step 24: Pull zipper to close.