Pack a Swoop in the AirPorter

Pack a Swoop in the AirPorter

Follow these steps to fit the Swoop D7i and Duo into the AirPorter.

Parts Inside the AirPorter:

695

 

1. Hub axle discs
2. Front drop out holder
3. Rear drop out holder
4. Chainring protector
5. Pedal bag
6. First pad
7. Second pad

 

Tools required:

 

15 mm crescent wrench

 

 

Step 1: Lay the AirPorter down flat, open up the cover and lay the buckles on the outside, then place the seatpost in the AirPorter, with saddle in the top left corner.

702

 

Step 2: Place the first pad over the seatpost.

703

 

Step 3: Fold the frame and handlepost. Place the folded frame on top of the first pad, crank-side down with the rear wheel on the right hand side, cranks at the bottom left and hinge on the bottom left hand side of the AirPorter.

705

 

Step 4: Wrap the rear frame half with the first pad and ensure that the seatpost and frame are protected by sufficient padding.

706

 

Step 5: Slide the seatpost between the front and rear frame halves, ensure that the seatpost and frame are protected by sufficient padding.

709

 

 

Step 6: Lift up the handlepost and then place the second pad over the frame and lay the handlepost on top of the second pad.

710

 

Step 7: Clasp the buckles shut and cinch tightly.

712

 

Step 8: Put the pedal bag into the zipper pocket on the inside of the AirPorter Cover.

713

 

Step 13: Close the AirPorter, zipper it up, set and lock the zipper lock.

714