AirPorter™ Slim Instructions

AirPorter™ Slim Instructions

For Verge and Link Users

Parts needed

  • Tern FlightSuit™

Tools needed

  • 15 mm Crescent Wrench
  • 5 mm Hex Key

Step 1: Remove both pedals using 15 mm crescent wrench.

Step 2: Remove both wheels. For wheels with nuts, use 15 mm crescent wrench.

Step 3: Insert dropout protectors into front and rear dropouts.

4894

4895

Step 4: Open Physis Handlepost lever. Remove Top Cap and loosen Top Cap Bolt.

4897

Step 5: Loosen both Steerer Clamp Bolts using 5 mm Hex Key.

4898

Step 6: Detach Physis Handlepost from frame.

4899

4900

 

Step 7: Put Top Cap, then Top Cap Bolt back onto steering tube and tighten.

4901

Step 8: If bike has rack or front fender, remove them. Remove seat post. Lay out all parts on floor.

4902

Step 9: Fold frame and put handlepost and handlebar socks over handlepost and handlebar.

4903 4904 4905

Step 10: Place AirPorter Slim on floor, open cover, and lay buckles on outside.

4906

Step 11: Place QR skewers into designated slots.

4907

Step 12: Place frame on top of padding with front frame half underneath rear frame half. Lay handlebar assembly on upper section of Airporter Slim. Rotate crank as shown below.

4909

Step 13: Place pedals in pedal bag. Then place as shown below.

4910

Step 14: Place padding on seatpost. Then place as shown below.

4911

Step 15: If bike has front fender, place it inside as shown below.

4912

Step 16: If bike has rear rack, place it inside as shown below.

4913

Step 17: Place handlebar assembly onto frame.

4914

Step 18: Fold padding over.

4915

Step 19: Place Rear Wheel on padding with cassette facing padding.

4916

Step 20: Place Front Wheel on padding partially overlapping Rear Wheel.

4917

Step 21: Fold padding over wheels.

4918

Step 22: Clasp buckles shut and cinch tightly.

4920

Step 23: Align top and bottom halves of Airporter Slim.

4921

Step 24: Pull zipper to close.

4922