Pack a Link in the AirPorter

Pack a Link in the AirPorter

Follow these steps to fit the Link D7i, D8, P7i, P9, P24h, and Uno into the AirPorter. 

Parts Inside AirPorter:


1. Hub axle discs
2. Front drop out holder
3. Rear drop out holder
4. Chain ring pad
5. Pedal bag
6. First pad
7. Second pad


Step 1: Attach the chain ring pad to the chain ring.


Step 2: Undo the seat clamp quick release and remove the seatpost. If quick release pedals are fitted, remove and place in the pedal bag.


Step 3: Lay the AirPorter down flat, open up the cover and lay the buckles on the outside, then place the seatpost in the Airporter, with saddle in the top left corner.


Step 4: Place the first pad over the seapost.


Step 5: Fold the frame and handlepost. Place the folded frame on top of the first pad, crank-side down with the rear wheel on the right hand side, cranks at the bottom and hinge on the left hand side of the AirPorter.


Step 6: Wrap the rear frame half with the first pad and ensure that the seatpost and frame are protected by sufficient padding.


Step 7: Place the second pad over the folded frame.


Step 8: Clasp the buckles shut and cinch tightly.


Step 9: If using quick release pedals, put the pedal bag into the zipper pockets on the inside of the AirPorter cover.



Step 10: Close the AirPorter and zipper it closed. Secure zippers in the zipper lock.