Pack a Verge in the AirPorter

Pack a Verge in the AirPorter

These instructions are for the Verge Duo, D9, N8, P9, P9L, P10, P18, P20, S8i, S11i, X10, X11 and X20 into the AirPorter. If your bike comes with VRO Stem, this should be adjusted flat such that the Brake Lever points upward.  

For the Verge X30h, please follow the Tern Tech Tip Pack a Verge X30h in the AirPorter.
For the Verge S27h/Tour, please follow the Tern Tech Tip Pack a Verge Tour(S27h) in the AirPorter.


Parts Inside the AirPorter: 

1. Hub axle discs (not required)
2. Front drop out holder (not required)
3. Rear drop out holder (not required)
4. Chainring protector
5. Pedal bag
6. First pad
7. Second pad



Step 1: Attach the chainring protector to the chainring.


Step 2: Lay the AirPorter down flat, open up the cover and lay the buckles on the outside, then place the seatpost in the AirPorter, with saddle in the top left corner.



Step 3: Place the first pad over the seatpost.



Step 4: Fold the frame and handlepost. Place the folded frame on top of the first pad, crank-side down with the rear wheel on the right hand side, cranks at the bottom and hinge on the left hand side of the AirPorter.



Note: For Verge S8i & Verge S11i, remove the Handlepost by loosening the Steerer Clamp Bolts and Top Cap Bolt, then reattach the Top Cap.









Step 5: Wrap the rear frame half with the first pad and ensure that the seatpost and frame are protected by sufficient padding.



Note: For Verge S11i and Verge S8i, slide the Handlepost in between the front and rear frame half. 


Step 6: Place the second pad over the folded frame.



Step 7: Clasp the buckles shut and cinch tightly.



Step 8: Close the AirPorter and zipper it closed. Secure zippers in the zipper lock.