Fitting a Link into the AirPorter

Fitting a Link into the AirPorter

Follow these steps to fit the Link D7i, D8, P7i, P9, P24h, and Uno into the AirPorter. 

Parts Inside AirPorter:

693

1. Hub axle discs
2. Front drop out holder
3. Rear drop out holder
4. Chain ring pad
5. Pedal bag
6. First pad
7. Second pad

 

Step 1: Attach the chain ring pad to the chain ring.

930

Step 2: Undo the seat clamp quick release and remove the seatpost. If quick release pedals are fitted, remove and place in the pedal bag.

661

Step 3: Lay the AirPorter down flat, open up the cover and lay the buckles on the outside, then place the seatpost in the Airporter, with saddle in the top left corner.

663

Step 4: Place the first pad over the seapost.

664

Step 5: Fold the frame and handlepost. Place the folded frame on top of the first pad, crank-side down with the rear wheel on the right hand side, cranks at the bottom and hinge on the left hand side of the AirPorter.

665

Step 6: Wrap the rear frame half with the first pad and ensure that the seatpost and frame are protected by sufficient padding.

666

Step 7: Place the second pad over the folded frame.

667

Step 8: Clasp the buckles shut and cinch tightly.

668

Step 9: If using quick release pedals, put the pedal bag into the zipper pockets on the inside of the AirPorter cover.

669

 

Step 10: Close the AirPorter and zipper it closed. Secure zippers in the zipper lock.

670